August 2022

Better Tackifier For Infusion Molding

What tackifier are you using for infusion molding? What impact does it have on the environment, your employees, and your manufacturing process? These are questions you should consider when choosing the best products for your infusion molding process. It’s important for you to understand if your tackifier is resin compatible, if it has sufficient tack

Better Tackifier For Infusion Molding Read More »

Solvent-Based vs Water-Based

Solvent-based vs water-based adhesives – what’s the scoop? Solvent-based adhesives use solvents as a carrier for the resin, whereas water-based adhesives use water as a carrier for the resin. Either type of adhesive can be beneficial, depending on the application. Both types are available in several different delivery systems, including canister systems. Water-based adhesives are usually

Solvent-Based vs Water-Based Read More »

Epoxy vs Methacrylate vs Urethane

Epoxy vs Methacrylate vs Urethane

Epoxy vs methacrylate vs urethane adhesives…what are they? They are all 2-part structural adhesives, but they have different ingredients and uses. They are all great alternatives to mechanical fasteners, uniformly distributing stress over the entire bond line, resulting in cost-savings and an increase in production capabilities. They have high cohesive strength and can permanently bond

Epoxy vs Methacrylate vs Urethane Read More »

Adhesive Overspray

Adhesive Overspray Removal | Effective Solutions

Adhesive Overspray Overspray…what is it? Overspray is extra adhesive that is sprayed out, that doesn’t actually land on the parts being bonded. Overspray is quite high with most adhesive spray systems, and can cost the user 30-70%. The problem with overspray, is that it’s wasted adhesive. That means there is a certain percentage of each

Adhesive Overspray Removal | Effective Solutions Read More »

Scroll to Top